ProVAL 3.61.10 Released
This revised version of 3.61 includes numerous fixes. The changes are listed in the Release Notes and also provided below.
Download ProVAL 3.61
Editor
- Improved route creation for cropped files.
Analysis
- Templates saved in a unit system other than the active one were not applied correctly.
Analysis – Smoothness Assurance
- Grinding screen sometimes did not show any locations.
- PDF report showed a non-existent profile when using IRI with a single-channel file.
- Long continuous PDF report was missing some units.
- Software could crash when using IRI with a single-channel file.
- Total Ground and head height were not converted correctly when changing the unit system.
- Any change to a grinding location might change the start and stop locations.
- Better handling of decimal places for grinding locations.
- Results were not converted when changing the unit system.
- Grinding chart might show the wrong elevation unit.
- Profiles in the grinding screen always used the comparison filter even if no comparison was selected.
Analysis – Optimal WIM Locator
- Total Ground and head height were not converted correctly when changing the unit system.
- Any change to a grinding location might change the start and stop locations.
- Better handling of decimal places for grinding locations.
- Lower threshold was being ignored.
Miscellaneous
- Migrating from ProVAL 2.7 to 3.6x might leave no analyses selected in the Options.